Evaporator Core: Service and Repair

A/C UNIT ASSEMBLY

EVAPORATOR : Removal and Installation


REMOVAL

1.Remove A/C unit assembly. Removal And Installation.
2.Disassemble A/C unit assembly, and then remove evaporator.
3.Remove intake sensor from evaporator. (Automatic air conditioning)
4.Remove thermo control amp. from evaporator. (Manual air conditioning)
5.Remove mounting bolts, and then remove expansion valve.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply compressor oil to them when installing.
- When install the intake sensor (Automatic air conditioning) or the thermo control amp. (Manual air conditioning), set the same position before replacement.
- Never rotate the bracket insertion part when removing and installing the intake sensor (automatic air conditioning) or the thermo control amp. (manual air conditioning).
- Perform lubricant adjusting procedure after installing new evaporator. Lubricant Adjusting Procedure For Components Replacement Except Compressor.