With Intelligent Key System

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

BCM : Work Procedure


1. SAVING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification. With Intelligent Key System.
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
- GO TO 2.

2. REPLACE BCM

Replace BCM. With Intelligent Key System.
- GO TO 3.

3. WRITING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. With Intelligent Key System.
- GO TO 4.

4. INITIALIZE BCM (NATS)

Perform BCM initialization. (NATS)
- WORK END