With Intelligent Key System

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

Work Procedure


1. SAVING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "READ CONFIGURATION" to save or print current vehicle specification. With Intelligent Key System.
NOTE:
If "READ CONFIGURATION" can not be used, use the "WRITE CONFIGURATION - Manual selection" after replacing BCM.
- GO TO 2.

2. REPLACE BCM

Replace BCM. With Intelligent Key System.
- GO TO 3.

3. WRITING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "WRITE CONFIGURATION - Config file" or "WRITE CONFIGURATION - Manual selection" to write vehicle specification. With Intelligent Key System.
- GO TO 4.

4. INITIALIZE BCM (NATS) (IF EQUIPPED)

Perform BCM initialization. (NATS)
- WORK END