Without Intelligent Key System

SYSTEM

BODY CONTROL SYSTEM : Fail-safe


FAIL-SAFE CONTROL BY DTC

BCM performs fail-safe control when any DTC are detected.






REAR WIPER MOTOR PROTECTION

BCM detects the rear wiper stopping position according to the rear wiper auto stop signal.
When the rear wiper auto stop signal does not change more than 5 seconds while driving the rear wiper, BCM
stops power supply to protect the rear wiper motor.
1.Pass more than 1 minute after the rear wiper stop.
2.Turn rear wiper switch OFF.
3.Operate the rear wiper switch or rear washer switch.

FAIL-SAFE CONTROL OF COMBINATION SWITCH READING FUNCTION CAUSED BY LOW


POWER SUPPLY VOLTAGE

If voltage of battery power supply lower, BCM maintains combination switch reading to the status when input voltage is less than approximately 9 V.
NOTE:
When voltage of battery power supply is approximately 9 V or more, combination switch reading function returns to normal operation.