Without Intelligent Key System

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

ECM : Work Procedure


1. PERFORM ECM RECOMMUNICATING FUNCTION

1.Install ECM.
2.Insert the registered ignition key* into key cylinder, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing ECM replacement.
3.Maintain ignition switch in the ON position for at least 5 seconds.
4.Turn ignition switch OFF.
5.Start the engine.
- GO TO 2.

2. PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM

Perform Work Procedure.
- END