P0328
P0327, P0328 KS
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1. PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.
- GO TO 2.
2. PERFORM DTC CONFIRMATION PROCEDURE
1.Start engine and run it for at least 5 seconds at idle speed.
2.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Proceed to .
NO- INSPECTION END
Diagnosis Procedure
1. CHECK KNOCK SENSOR GROUND CIRCUIT
1.Turn ignition switch OFF.
2.Disconnect knock sensor harness connector.
3.Disconnect ECM harness connector.
4.Check the continuity between knock sensor harness connector and ECM harness connector.
5.Also check harness for short to power.
Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace error-detected parts.
2. CHECK KNOCK SENSOR INPUT SIGNAL CIRCUIT
1.Check the continuity between knock sensor harness connector and ECM harness connector.
2.Also check harness for short to ground and to power.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair open circuit or short to ground or short to power in harness or connectors.
3. CHECK KNOCK SENSOR
Check the knock sensor. .
Is the inspection result normal?
YES- Check intermittent incident. Intermittent Incident.
NO- Replace knock sensor. Exploded View.
Component Inspection
1. CHECK KNOCK SENSOR
1.Turn ignition switch OFF.
2.Disconnect knock sensor harness connector.
3.Check resistance between knock sensor terminals as per the following.
NOTE:
It is necessary to use an ohmmeter which can measure more than 10 M Ohms.
CAUTION:
Do not use any knock sensors that have been dropped or physically damaged. Use only new ones.
Is the inspection result normal?
YES- INSPECTION END
NO- Replace knock sensor. Exploded View.