Removal And Installation

REAR DOOR GLASS

Removal and Installation


REMOVAL

1.Remove rear door finisher. Removal And Installation.
2.Fully open rear door glass.
3.Remove power window switch finisher bracket. Exploded View.
4.Remove rear door speaker harness connector and rear sealing screen.
NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.
5.Remove rear door outside molding. .
6.Remove partition sash mounting bolts and screw.
7.Remove partition sash.
- Remove rear door glass run from partition sash.
- Slightly pull straight down partition sash.
- From the upper side, slop partition sash toward vehicle front and then remove.





8.Operate the power window switch to raise/lower the door window until the glass mounting bolts can be seen.
9.Remove the glass mounting bolts (A).
10.Remove rear door glass from the rear door panel.





11.Remove partition glass.
- Slide partition glass toward the arrow 1.
- Pull partition toward the direction of arrow 2 to remove.
- Remove partition weather-strip after removing the partition glass.
12.Remove rear door glass run fixing clip and remove rear door glass run.

INSTALLATION

Install in the reverse order of removal.