Removal And Installation

CVT OIL WARMER SYSTEM

WATER HOSE : Removal and Installation


REMOVAL


WARNING:
Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator.

CAUTION:
Perform this step engine is cold.
1.Remove air duct (inlet). Exploded View.
2.Remove hose clamps, and remove CVT water hose A.
3.Remove hose clamps, and remove CVT water hose B.
4.Remove hose clamps, and remove CVT water hose C.
5.Remove CVT water tube.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Insert CVT water hose according to dimension "A" described below.










- Set hose clamps (1) at the both ends of fluid cooler hose (2) with dimension "A" from the hose edge.
Dimension "A": 5 - 7 mm (0.20 - 0.28 in)
- Hose clamp should not interfere with the bulge.










- The illustrations indicate the view from the hose ends.

White arrow D : Vehicle front
White arrow E : Vehicle upper

- When installing hose clamps the center line of each clamp tab should be positioned as shown in the figure.