Removal And Installation

CVT OIL WARMER SYSTEM

CVT FLUID COOLER HOSE : Removal and Installation


REMOVAL

1.Remove air duct (inlet). Exploded View.
2.Remove hose clamps, and remove CVT fluid cooler hose A.
3.Remove hose clamps, and remove CVT fluid cooler hose B.
4.Remove CVT fluid cooler tube A and CVT fluid cooler tube B.

INSTALLATION

Note the following, and install in the reverse order of removal.





- When installing CVT fluid cooler tube (1) and (2) to transaxle assembly, install them so that CVT fluid cooler tube rotation stopper (A) and (B) touch to transaxle case (C) and (D).

White arrow indicates : Vehicle front






- Insert CVT fluid cooler hose according to dimension "A" described below.










- Set hose clamps (1) at the both ends of fluid cooler hose (2) with dimension "A" from the hose edge.
Dimension "A": 5 - 7 mm (0.20 - 0.28 in)
- Hose clamp should not interfere with the bulge.










- The illustrations indicate the view from the hose ends.

White arrow B : Vehicle front

- When installing hose clamps the center line of each clamp tab should be positioned as shown in the figure.