Removal And Installation

KEY INTERLOCK CABLE

Removal and Installation


REMOVAL


CAUTION:
Make sure that parking brake is applied before removal/installation.
1.Remove selector lever knob. Exploded View.
2.Remove center console. Exploded View.
3.Slide slider (A) toward casing cap (B) while pressing tabs (C) on slider to separate slider from adjust holder (D).










4.Remove steering column cover lower and instrument driver lower panel. Exploded View.





5.Pull out the lock plate (A) from the holder (B).
6.Remove the key interlock cable (1) from the key cylinder (2).
7.Remove clip and remove key interlock cable.

INSTALLATION






- Temporarily install adjust holder (A) to key interlock rod (B). Install casing cap (C) to cable bracket (D) on CVT shift selector assembly.

CAUTION:
- Never bend or twist key interlock cable excessively when installing.
- Check that casing cap is firmly secured in cable bracket on
CVT shift selector assembly after installing key interlock cable to cable bracket on CVT shift selector assembly.





- Slide the slider (A) toward the key interlock rod (D) while pressing the pull lock (B) down to securely connect the adjust holder (C)
with the key interlock rod (D).

CAUTION:
- Never press tabs when holding slider.
- Never apply any force at a right angle to key interlock rod when sliding.