Removal And Replacement

CLUTCH PEDAL

Removal and Installation


REMOVAL

1.Disconnect ASCD clutch switch connector. (With ASCD)
2.Disconnect clutch interlock switch connector.
3.Disconnect clip of harness from clutch pedal.





4.Remove master cylinder rod end (black arrow) from clutch pedal.
5.Remove ASCD clutch switch and clip from clutch pedal. (With
ASCD)
6.Remove clutch interlock switch, clip, and pedal pad from clutch pedal.
7.Remove stopper rubber and pedal stopper rubber from clutch pedal, using a suitable remover.
8.Remove clutch pedal from the vehicle.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
Press master cylinder rod end into clutch pedal until it stops.