Removal And Installation

COIL SPRING

Removal and Installation


REMOVAL

1.Remove tires with power tool. Exploded View.
2.Set jack under rear suspension beam.

CAUTION:
Check the stable condition when using a jack.
3.Remove right and left rear shock absorber mounting bolts (lower side). Exploded View.
4.Slowly lower jack, then remove upper rubber seat, coil spring and lower rubber seat from rear suspension beam.

CAUTION:
Check the stable condition when using a jack.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Install the lower rubber seat a projection (A) is attached as rear suspension beam mounting hole (B).
- Match up lower rubber seat indentions and rear suspension beam grooves and attach.