Removal And Installation

REAR SUSPENSION BEAM

Removal and Installation


REMOVAL

1.Remove tires with power tool. Exploded View.
2.Drain brake fluid. Draining.
3.Remove parking brake cable and brake drum from rear suspension beam. Exploded View, Exploded View.
4.Remove wheel sensor and sensor harness. Exploded View.
5.Set suitable jack under rear suspension beam.

CAUTION:
Check the stable condition when using a jack.
6.Remove shock absorber mounting bolts (lower side). Exploded View.
7.Remove coil springs. Exploded View.
8.Separate brake hose and brake tube. Exploded View.
9.Remove suspension arm bracket mounting bolts.
10.Slowly lower jack, remove suspension arm bracket and rear suspension beam from vehicle body.

CAUTION:
Check the stable condition when using a jack.
11.Remove wheel hub and bearing assembly. Exploded View.
12.Remove drum brake assembly. Exploded View.
13.Remove suspension arm bracket from rear suspension beam.
14.Remove brake tube protector from rear suspension beam.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Perform final tightening of rear suspension beam installation position (rubber bushing), under unladen conditions with tires on level ground.
- Refill with new brake fluid and perform the air bleeding. Refilling.