Removal And Installation

STARTER MOTOR

Removal and Installation


REMOVAL

1.Disconnect the battery cable from the negative terminal.
2.Remove air duct (inlet). Exploded View.
3.Remove radiator reservoir tank.
4.Disconnect oil pressure switch connector.
5.Remove "B" terminal nut and "B" terminal harness.
6.Remove "S" terminal nut and "S" terminal harness.
7.Remove starter motor mounting bolts.
8.Remove starter motor upward from the vehicle.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
Be careful to tighten "B" terminal nut to the specified torque.