Removal And Installation

CURTAIN AIR BAG MODULE

Removal and Installation


WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
- Always work from the side of curtain air bag module. Never work in front of it.
- Never use the air tools or electric tools for servicing.

REMOVAL

1.Remove the headlining. Exploded View.





2.Disconnect harness connector (A) when removing the curtain air bag module RH.
3.Disconnect harness connector (B) and disengage harness clips (C) when removing the curtain air bag module LH.

CAUTION:





- For installing/removing the curtain air bag module harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove the connector.
- Install the connector with lock raised, and push lock into the connector.
- After installing the connector, check that the lock is pushed securely into it.
4.Remove the fixing bolts, and then remove the curtain air bag module.

CAUTION:





- Never impact the curtain air bag module.
- Replace the curtain air bag module if it has been dropped or sustained an impact.
- Never insert any foreign objects (screwdriver, etc.) into the curtain air bag module.
- Never disassemble the curtain air bag module.
- Never expose the curtain air bag module to temperatures exceeding 90 �C (194 �F).
- Never allow oil, grease, detergent, or water to come in contact with the curtain air bag module.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
- When installing, always be careful not to drop curtain air bag module and install mounting bolts according to the order as shown in the figure.





- Never damage the harness while installing.
- If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT. Supplemental Restraints.
- After the work is completed, check that no system malfunction is detected by air bag warning lamp.