Removal And Installation

ACCELERATOR CONTROL SYSTEM

Removal and Installation


REMOVAL

1.Disconnect accelerator pedal position sensor harness connector.
2.Loosen mounting bolts, and remove accelerator pedal assembly.

CAUTION:
- Never disassemble accelerator lever. Never remove accelerator pedal position sensor from accelerator lever.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator lever away from water.
3.Fold the floor carpet and remove accelerator pedal stopper.
- Remove pedal stopper by turning it counterclockwise with fingers.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Insert locating pin into vehicle side to position accelerator pedal assembly. Tighten mounting bolts to accelerator pedal assembly.