Removal And Installation

WATER OUTLET

Removal and Installation


REMOVAL

1.Drain engine coolant from radiator. Draining Engine Coolant.

CAUTION:
- Perform this step when engine is cold.
- Never spill engine coolant on drive belt.
2.Remove air duct (inlet) and resonator assembly and each air ducts. Exploded View.
3.Disconnect radiator hose (upper). Exploded View.
4.Disconnect harness connector from engine coolant temperature sensor.
5.Remove water hoses.
6.Remove heater hoses.
7.Remove water outlet.
8.Remove engine coolant temperature sensor from water outlet, if necessary.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Install water control valve with making rubber ring (1) groove fit to water control valve flange (A) with the whole circumference.





- Install water control valve (2) with the arrow (A) facing up and the frame center part (B) facing upwards.