Removal And Installation

BRAKE PEDAL

Removal and Installation


REMOVAL

1.Remove instrument lower panel LH. Exploded View.
2.Remove knee protector. Removal And Installation.
3.Disconnect the stop lamp switch and ASCD brake switch (with ASCD) harness connectors.
4.Disconnect the accelerator pedal harness connector and clip.
5.Remove snap pin and clevis pin from clevis.
6.Remove the brake pedal assembly.
7.Remove accelerator pedal from brake pedal assembly. Exploded View.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been already applied)
NOTE:
The clevis pin may be inserted in either direction.