Removal And Installation

ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Removal and Installation


REMOVAL

1.Disconnect the battery cable from negative terminal.
2.Remove cowl top cover and extension cowl top. Exploded View.
3.Drain brake fluid. Draining.
4.Disconnect ABS actuator and electric unit (control unit) harness connector.
5.Loosen brake tube flare nuts, and then remove brake tubes from ABS actuator and electric unit (control unit). Exploded View.

CAUTION:
Never scratch the flare nut and the brake tube.
6.Remove ABS actuator and electric unit (control unit) and bracket from vehicle.

CAUTION:
- Never apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
- Never remove actuator by holding harness.
7.Remove bracket and bush from ABS actuator and electric unit (control unit).

INSTALLATION

Note the following, and install in the reverse order of removal.
- Install, use flare nut crowfoot and torque wrench. Exploded View.

CAUTION:
Never scratch the flare nut and the brake tube.
- Never apply excessive impact to ABS actuator and electric unit (control unit), such as dropping it.
- Never install actuator by holding harness.
- Installing harness connector in the ABS actuator and electric unit (control unit), make sure harness connector is securely locked.