Front Seat

FRONT SEAT

Disassembly and Assembly


DISASSEMBLY

1.Remove the armrest assembly.
- Remove the armrest cap.
- Remove the mounting bolt, and then remove armrest assembly.
2.Remove the seatback trim and seatback pad.
- Remove seatback retainer installed in the lower portion of seat cushion.
- Remove harness installed in the lower portion of seat cushion





- Remove the seatback retainer (1), and then open the fastener (2).
- Disconnect seat heater unit harness connector. (heater seat model only)
- Remove the seatback retainer from seatback inside.





- Remove the headrest holder.

CAUTION:
Before installing headrest holder check its orientation.
(front/rear and right/left)
- Remove the side air bag module mounting nuts.
- Remove the seatback trim and seatback pad from the seatback frame.
- Remove the hog rings, and separate the seatback trim and seatback pad.
3.Separate the seatback pad and seatback heater unit.
4.Remove the seatback silencer.
5.Remove the seat cushion outer finisher.





- Remove the pawls, and then lifter lever knob finisher (1).
(Driver's seat only)

Broken triangle indicates : Pawl

- Remove the mounting screws, and remove the lifter lever (2).
(Driver's seat only)





- Pull out the reclining lever while holding and raising the pawl.

Broken triangle indicates : Pawl






- Remove the metal clip and pawls, and then pull out seat cushion outer finisher outside.

Broken square indicates : Metal clip
Broken triangle indicates : Pawl






6.Remove the metal clip and pawls, and then pull out seat cushion inner finisher.

Broken square indicates : Metal clip
Broken triangle indicates : Pawl

7.Remove the seat belt buckle. Removal And Installation.
8.Remove the seat cushion assembly.
- Remove the seat cushion trim retainer.
- Remove the seat cushion assembly from the seat cushion frame.
9.Remove the seat cushion silencer.
10.Remove the reclining device cover.
- Remove the screws, and then reclining device outer cover (front, rear).
- Remove the screws, and then reclining device inner cover (front, rear).
11.Remove the mounting bolt, and then remove seatback frame.
12.Remove the following parts after removing seatback frame.
- Remove the seat cushion mat.
- Remove occupant detection system control unit. Removal And Installation.
Assembly
Assemble in the reverse order of disassembly.

CAUTION:
Install the hog rings of seat trim in position, and then securely connect the trim or trim cord with the pad side wire.