Without Intelligent Key System

BACK DOOR LOCK

DOOR LOCK : Removal and Installation


REMOVAL

1.Remove back door finisher lower. Removal And Installation.
2.Remove sealing screen.
NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.
3.Remove back door outside handle. Without Intelligent Key System.
4.Remove back door lock assembly mounting bolts.
5.Disconnect harness connector from back door lock assembly.
6.Remove back door lock assembly.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Check back door open/close, lock/unlock operation after installation.
- Check door lock cable is properly engaged with outside handle bracket.