With Intelligent Key System

BACK DOOR

BACK DOOR ASSEMBLY : Removal and Installation


CAUTION:
Perform work with 2 workers, because of its heavy weight.

REMOVAL

1.Remove back door finisher lower. Refer to Removal And Installation.
2.Remove luggage side finisher (LH) (upper/lower). Removal And Installation.





3.Remove ground bolt (A) and disengage connections of harness connectors (B) and rear washer hose (C).
4.Remove back door harness grommet, and then pull out the harness from the vehicle.
5.Support back door with the proper material to prevent it from falling.
6.Remove mounting bolt of door check link on the vehicle.
7.Remove back door hinge mounting bolts (back door side), and then remove back door assembly.
8.Remove the following parts after removing back door assembly.
- Back door finisher upper
- Sealing screen
- Dovetail (male)
- Dovetail (female)
- Door check link
- Grommet
- Bumper rubber

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Check back door open/close, lock/unlock operation after installation.
- After installation, perform fitting adjustment. With Intelligent Key System.