Intake Valve Timing Control Solenoid Valve (RH) (Bank 1)

INTAKE VALVE TIMING CONTROL

Intake Valve Timing Control Solenoid Valve (RH) (bank 1)


REMOVAL

1.Remove hood ledge cover.
2.Remove coolant reservoir and set aside.
3.Remove power steering reservoir and set aside.
4.Support engine using suitable tool.
5.Remove upper engine mount and bracket. Removal and Replacement.
6.Remove Intake valve timing control solenoid valve cover bolt behind solenoid valve. Component.
7.Disconnect Intake valve timing control solenoid valve connector.
8.Remove Intake valve timing control solenoid valve and O-ring from Intake valve timing control solenoid valve cover.

CAUTION:
Do not reuse O-ring.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Do not reuse O-ring.
- Replace the O-ring for the Intake valve timing control solenoid valve with a new one, then lubricate
O-ring with engine oil before installing.
Intake valve timing control solenoid valve bolt: 11.3 Nm (1.2 kg-m, 8 ft-lb)