Removal And Installation

REAR DOOR GLASS

Removal and Installation


REMOVAL

1.Remove the rear door finisher. Removal And Installation Sedan.
2.Remove the vapor barrier, being careful not to tear/damage it.
3.Temporarily reconnect the power window switch to the door harness.





4.Operate the power window switch to raise/lower the door glass until the door glass bolts (A) can be seen through access hole as shown.
5.Remove the door glass bolts (A).
6.Remove the door glass.





7.Remove the partition sash from the glass run.
- Remove the partition sash bolt (lower) (B) and screw (upper)
(A) to remove the sash.





8.Remove the partition glass from the inside of the door in the direction as shown.

INSTALLATION

Installation is in the reverse order of removal.
- After installation inspect and adjust as necessary.