Removal And Installation

M/T SHIFT SELECTOR

Removal and Installation


REMOVAL

1.Remove instrument lower panel (LH). Instrument Lower Panel LH.
2.Remove console side finishers (LH) and (RH). Exploded View.
3.Remove shift selector handle.
4.Remove M/T finisher. Exploded View.
5.Remove the shift cable from the shift selector assembly.
6.Remove the select cable from the shift selector assembly.
7.Remove the shift selector assembly bolts and the shift selector assembly.

INSTALLATION

Installation is in the reverse order of removal.
- Install shift selector handle according to the following.
- Apply cement to threads of shift selector.





- Tighten shift selector handle until increased tension is felt. Then align shift selector handle to the position as shown within one turn.
- arrow indicates: Front

CAUTION:
Do not adjust shift selector handle by loosening it.
- Adjust select cable as necessary. Adjustments.
- After assembly, make sure shift selector automatically returns to Neutral position when it is moved to 1st/2nd or reverse gate.
- When shift selector is moved to each position, make sure there is no binding or disconnection of cables.