Refilling

M/T OIL

Refilling






1.Remove the filler plug (1) and fill transaxle with new oil.
Oil grade : Recommended Chemical Products And Sealants.
2.After refilling oil, measure oil level to check if it is within the specification using suitable gauge (A) as shown.

CAUTION:
- Do not start engine while checking oil level.
- Insert the suitable gauge straight and against the wall of the filler plug hole, then measure the gauge from the top of the filler plug hole to the oil level as shown.
Oil level (L): General Specifications.
3.Install the filler plug with a new O-ring to the clutch housing.

CAUTION:
Do not reuse O-ring.
4.Tighten filler plug bolt to the specified torque. Exploded View.