Removal and Replacement

CLUTCH PIPING

Removal and Installation


CAUTION:
Do not spill clutch fluid onto painted surfaces. If it spills, wipe up immediately and wash the affected area with water.

REMOVAL

1.Remove cowl top. Coupe (Coupe models) or Sedan (Sedan models).
2.Remove engine room cover.
3.Remove the air cleaner and air duct. Service and Repair (QR25DE models) or
Service and Repair (VQ35DE models).
4.Remove the lock pin and disconnect the clutch master cylinder connector.
NOTE:
Cap or plug opening(s) to prevent fluid from spilling.
5.Remove the clutch tubes from the branch connector.
NOTE:
Cap or plug opening(s) to prevent fluid from spilling.
6.Remove the clutch tube and air bleed connector valve.
NOTE:
Cap or plug opening(s) to prevent fluid from spilling.
7.Remove the branch connector.
NOTE:
Cap or plug opening(s) to prevent fluid from spilling.
8.Remove lock pin and disconnect the CSC connector.
NOTE:
Cap or plug opening(s) to prevent fluid from spilling.

INSTALLATION

Installation is in the reverse order of removal.
- Make sure that all tubes are fully installed into connectors.
- Make sure that all connector lock pins are fully installed.
- After installation, bleed clutch hydraulic system. Service and Repair.
CL