Removal And Installation

SIDE CURTAIN AIR BAG MODULE

Removal and Installation


REMOVAL


CAUTION:
- Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Do not use air tools or electric tools for servicing.
- Always work from the side of air bag module. Do not work from the front of it.
- Always place the curtain air bag module with air bag deployment side facing upward.
- Do not cause impact to the air bag module by dropping etc. Replace the air bag module if it has been dropped or sustained an impact.
1.Disconnect the negative and positive battery terminals, then wait at least three minutes.
2.Remove the headlining. Removal And Installation Coupe (Coupe), or Removal And Installation Sedan (Sedan).
3.Disconnect the side curtain air bag module connector.





- For installing/removing direct-connect SRS connectors, SRS Component Connectors.
4.Remove the bolts, then remove side curtain air bag module.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Be careful not to damage the air bag harness.
- Check the entire side curtain air bag module to make sure it is not twisted and there is no broken tape. If the side curtain air bag module is twisted or the tape is broken, the module must be replaced as an assembly.
- After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
- In case a malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by CONSULT.
- If a malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Component Tests and General Diagnostics.