Rear Wheel Hub

WHEEL HUB

Removal and Installation












REMOVAL


CAUTION:
Wheel hub assembly does not require maintenance. If any of the following symptoms are noted, replace the wheel hub assembly.
- A growling noise is emitted from the wheel hub assembly while driving.
- The wheel hub assembly drags or turns roughly.
1.Remove the rear wheel and tire.
2.Remove the brake torque member, caliper and pads as an assembly using power tool, then remove the disc rotor. Removal And Installation.

CAUTION:
- Do not twist or stretch the brake hose.
- Do not drop the pads or shims.
NOTE:
- The brake hose does not need to be disconnected from the brake caliper.
- Suspend the brake torque member, caliper and pads as an assembly using wire.
- Do not depress the brake pedal, or the caliper piston will pop out.
3.Remove the rear wheel sensor, then move it away from the wheel hub assembly. ABS (ABS), VDC/TCS/ABS (VDC/TCS/ABS).

CAUTION:
Failure to remove the wheel sensor may result in damage to the sensor wires and the sensor being inoperative.
RAX
4.Remove the wheel hub assembly from knuckle.

INSPECTION AFTER REMOVAL

Check for any wear, cracks, or damage on the wheel hub assembly, replace if necessary.

INSTALLATION

Installation is in the reverse order of removal.
- Check that the wheel bearings operate smoothly.





- Check that the wheel hub bearing axial end play is within specification.
Axial end play: Specifications.
- Install wheel and tire, tightening to specification. Adjustment.