Removal and Installation

COOLING FAN

Removal and Installation












WARNING:
Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure engine coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly turn it a quarter of a turn to release built-up pressure. Carefully remove radiator cap by turning it all the way.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

1.Partially drain engine coolant from the radiator. Service and Repair.

CAUTION:
Perform when engine is cold.
2.Remove front air duct. Service and Repair.
3.Disconnect radiator hose (upper).
4.Disconnect fan motor connectors.
5.Remove radiator cooling fan assembly.

INSTALLATION

Installation is in the reverse order of removal.
- After installation refill engine coolant and check for leaks. Service and Repair and
Initial Inspection and Diagnostic Overview.

CAUTION:
Do not spill coolant in engine compartment. Use a shop cloth to absorb coolant.
- Cooling fan is controlled by ECM. For details, For USA And Canada.