Rear Window Defogger Switch Circuit Inspection

REAR WINDOW DEFOGGER


Rear Window Defogger Switch Circuit Inspection

1.CHECK REAR WINDOW DEFOGGER SWITCH OPERATION
With CONSULT-III
Check ("REAR DEF SW", "IGN ON SW") in DATA MONITOR mode with CONSULT-III.






Without CONSULT-III





1. Turn ignition switch ON.
2. Check voltage between BCM connector and ground.






OK or NG
OK - Rear window defogger switch check is OK.
NG - GO TO 2.
2.CHECK REAR WINDOW DEFOGGER SWITCH CIRCUIT HARNESS CONTINUITY





1. Turn ignition switch OFF.
2. Disconnect BCM and front air control.
3. Check continuity between BCM connector M18 (A) terminal 10 and front air control connector M33 (B) terminal 38.






4. Check continuity between BCM connector M18 (A) terminal 10 and ground






OK or NG
OK - GO TO 3.
NG - Repair or replace harness.
3.CHECK REAR WINDOW DEFOGGER SWITCH





Check continuity between front air control terminals.






OK or NG
OK - GO TO 4.
NG - Replace front air control. Service and Repair, "Removal
and Installation".
4.CHECK REAR WINDOW DEFOGGER SWITCH GROUND





Check continuity between front air control connector and ground.






OK or NG
OK - GO TO 5.
NG - Repair or replace harness.
5.CHECK BCM OUTPUT SIGNAL





1. Connect BCM.
2. Turn ignition switch ON.
3. Check voltage between BCM connector M18 terminal 10 and ground.






OK or NG
OK - Replace front air control. Service and Repair.
NG - Replace BCM. Programming and Relearning Service and Repair.