Initial Inspection and Diagnostic Overview

DOUBLE METERS


Trouble Diagnosis


HOW TO PERFORM TROUBLE DIAGNOSIS
1. Confirm the symptom or customer complaint.
2. Perform preliminary check. Refer to "PRELIMINARY CHECK".
3. According to the symptom chart, repair or replace the cause of the symptom. SEE Trouble Diagnosis Double Meters Power Supply And Ground Circuit Inspection, "Symptom
Chart".
4. Does the double meter operate normally? If so, GO TO 5. If not, GO TO 2.
5. Inspection End.

PRELIMINARY CHECK
1.CHECK COMBINATION METER (CONSULT-III)
Select "METER/M&A" on CONSULT-III and perform self-diagnosis of combination meter. Scan Tool Testing and Procedures, "CONSULT-III Function (METER/M&A)".
Self-diagnostic results content
No malfunction detected- Double Meters.
Malfunction detected- .