Removal And Installation For High-Pressure Pipe

REFRIGERANT LINES


Removal and Installation for High-pressure Pipe


REMOVAL
1. Discharge the refrigerant. HFC-134A (R-134A) Service Procedure.
2. Reposition the lower dash insulator.
3. Disconnect the low-pressure flexible hose bracket to reposition it out of the way.
4. Remove the high-pressure pipe. Locations.

CAUTION:
Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- Replace the O-ring of the high-pressure pipe with a new one, then apply compressor oil to it when installing it.
- After charging the refrigerant, check for leaks. Checking Of Refrigerant Leaks.