Front Door Window Regulator: Adjustments

FRONT REGULATOR

Inspection and Adjustment


Inspection after removal

Check the front regulator for the following items. Replace or grease it if a malfunction is detected.
- Wire wear
- Front regulator deformation
- Grease condition for each sliding part

SYSTEM INITIALIZATION

Initialize the system if any of the following work is complete. Refer to "Work Procedure" Work Procedure.

FITTING INSPECTION

- Check that the glass is fit securely into the sash groove.
- Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)], and check that the clearance to the sash is parallel. Loosen the regulator mounting bolts, guide rail mounting bolts, and glass and guide rail mounting bolts to correct the glass position if the clearance between the glass and sash is not parallel.