Draining And Refilling

REDUCTION GEAR OIL

Draining and Refilling


DRAINING

1.Turn the power switch OFF.
2.Remove filler plug.
3.Remove drain plug (1) and drain gear oil.
4.Set a gasket on drain plug and install it to reduction gear and tighten to the specified torque. Exploded View.

CAUTION:
- Never reuse gasket.
- If foreign matter, such as gear abrasion powder, is on the magnet of the drain plug, wipe it free of adherents before installation.






REFILLING

1.Remove filler plug (1). Fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.






2.After refilling oil, check oil level. Set a gasket on filler plug, then install it to reduction gear. Exploded View.

CAUTION:
- Never reuse gasket.
- If foreign matter, such as gear abrasion powder, is on the magnet of the filler plug, wipe it free of adherents before installation.