Inspection And Adjustment

FRONT SUSPENSION MEMBER

Inspection and Adjustment


INSPECTION AFTER REMOVAL

Check front suspension member for cracks, wear or damage. Replace it if necessary.

INSPECTION AFTER INSTALLATION

1.When all parts are installed, be sure to check equipotential of traction motor, electric compressor, and traction motor inverter.
- Traction motor: Refer to "Inspection and Adjustment" Inspection And Adjustment.
- Electric compressor: Refer to "Inspection" Electric Compressor Inspection.
- Traction motor inverter: Refer to "Inspection and Adjustment"
2.Check wheel alignment. Refer to "Inspection" Wheel Alignment Inspection.

ADJUSTMENT AFTER INSTALLATION

It is necessary to clear the P position learning value and perform the relearning of the P position after the parking actuator harness connector is removed. Refer to "Work Procedure" Work Procedure.