Power Switch Does Not Operate

POWER SWITCH DOES NOT OPERATE

Description

The power switch position does not change even if the power switch (push switch) is operated.
Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis, and check each symptom.
NOTE:
The READY set function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent
Key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.

Conditions of Vehicle (Operating Conditions)

- "ENGINE START BY I-KEY" in "WORK SUPPORT" is ON when setting on CONSULT.
- One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.


Diagnosis Procedure


1. PERFORM WORK SUPPORT

Perform "INSIDE ANT DIAGNOSIS" on Work Support of "INTELLIGENT KEY".
Refer to "INTELLIGENT KEY : CONSULT Function (BCM INTELLIGENT KEY)" Intelligent Key.
- GO TO 2.

2. PERFORM SELF-DIAGNOSIS RESULT

Perform Self-Diagnosis Result of "BCM".
Is DTC detected?
NO- GO TO 3.

3. CHECK POWER SWITCH (PUSH SWITCH)

Check power switch (push switch).
Refer to "ComponentFunctionCheck" Power Switch.
Is the operation normal?
YES- GO TO 4.
NO- Repair or replace malfunctioning parts.

4. CONFIRM THE OPERATION

Confirm the operation again.
Is the inspection normal?
YES- Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.
NO- GO TO 1.