If Needed For Section 2 - GR8 Multitasking Battery Diagnostic

---- If Needed for Section 2 - Software Update: TCU ----

GR8 Multitasking Battery Diagnostic Station Set-Up

1. Confirm the vehicle is OFF.

2. Connect the battery tester/charger to the 12-volt battery, positive cable first.

3. Plug in the battery tester/charger (AC voltage supply).

4. Turn ON the battery tester/charger.

5. Select the preferred language, then select NEXT.

6. Select the USER, then select NEXT.

7. Confirm the USER, then select NEXT.

8. Select System Test, and then select the down arrow.

9. Select the Manual icon, then select NEXT.

10. Select REGULAR FLOODED, then select NEXT.

11. Select LIMIT VOLTAGE, then select NEXT.

12. Set MIN VOLTAGE to 12.40 volts, then select NEXT.

^ Use the arrows to raise and lower the voltage setting.

13. Set the charging time for 40 minutes, then select NEXT.

14. Wait for the system to go through Test mode and Advanced Test mode.

15. Perform TCU software update.

16. Once the TCU software update has completed:

a) Push the vehicle power switch once to OFF mode.

b) Select STOP on the battery tester/charger.

c) Push the power switch to OFF.

d) Unplug the battery tester/charger from the AC voltage supply.

NOTE:
For further details on battery tester/charger connection and set-up, refer to the battery tester/chargers instruction manual.