Front Combination Lamp

FRONT COMBINATION LAMP

Replacement


CAUTION:
- Disconnect the 12V battery negative terminal or remove the fuse to electric leakage. Refer to "Precaution for Removing 12V Battery" Precaution For Removing 12V Battery.
- After installing the bulb, install the resin cap and the bulb socket securely for watertightness.
- Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it to prevent damage to the bulb.
- Never touch bulb by hand while it is lit or right after being turned off to prevent a burns.
- Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.

PARKING LAMP BULB






1.Rotate resin cap (1) counterclockwise and unlock it.





2.Rotate parking lamp bulb socket (1) counterclockwise and unlock it.
3.Remove parking lamp bulb from bulb socket.

HEADLAMP BULB (LO)

LED is used for headlamp bulb (LO). Always replace front combination lamp assembly as a unit, when bulb is to be replaced because of malfunction.

HEADLAMP BULB (HI)






1.Rotate resin cap (1) counterclockwise and unlock it.
2.Remove parking lamp bulb and socket.





3.Rotate headlamp bulb (HI) (2) counterclockwise and unlock it.
4.Disconnect headlamp bulb (HI) harness connector (1).
5.Remove headlamp bulb (HI) from the headlamp housing assembly.

FRONT TURN SIGNAL LAMP BULB

1.Rotate bulb socket counterclockwise and unlock it.
2.Remove bulb from the bulb socket.

FRONT SIDE MAKER LAMP BULB

1.Rotate bulb socket counterclockwise and unlock it.
2.Remove bulb from the bulb socket.