Led Headlamp Operation Inspection

LED HEADLAMP OPERATION INSPECTION

Diagnosis Procedure


1. CHECK START

1.In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF
headlamp for the several times. Check that headlamp operates normally each time.
2.In the cool LED status, turn headlamp ON, wait until headlamp enters to the stable status (approximately
5 minutes after turning headlamp ON), and then check that headlamp operates normally without blinking or flickering.
3.In the warm LED status (turn headlamp ON for more than 15 minutes and wait for 1 minute after turning
OFF), turn ON and turn OFF headlamp for the several times. Check that headlamp operates normally each time.
4.Turn headlamp ON for approximately 30 minutes, and then check that headlamp operates normally without difference in brightness between LH and RH, blinking or flickering.
Is the inspection result normal?
YES- INSPECTION END
NO- Refer to "WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table" Symptom Table Without Daytime Running Light System.