Take Away Warning Does Not Operate

TAKE AWAY WARNING DOES NOT OPERATE

Diagnosis Procedure


1. CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.
Is the inspection result normal?
YES- GO TO 2.
NO-1- Refer to "DTC Index" (BCM)
NO-2- Refer to "DTC Index" (Combination meter)

2. CHECK COMBINATION METER BUZZER

Check combination meter buzzer.
Refer to "ComponentFunctionCheck" Intelligent Key Warning Buzzer.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace the malfunctioning parts.

3. CHECK INFORMATION DISPLAY

Check information display.
Refer to "ComponentFunctionCheck" Information Display.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace the malfunctioning parts.

4. CHECK INTELLIGENT KEY WARNING BUZZER

Check Intelligent Key warning buzzer.
Refer to "ComponentFunctionCheck" Intelligent Key Warning Buzzer.
Is the inspection result normal?
YES- GO TO 5.
NO- Repair or replace the malfunctioning parts.

5. CHECK DOOR SWITCH

Check door switch.
Refer to "ComponentFunctionCheck" Door Switch.
Is the inspection result normal?
YES- GO TO 6.
NO- Repair or replace the malfunctioning parts.

6. CHECK INSIDE KEY ANTENNA

Check inside key antenna.
- Instrument center: Refer to "DTC Logic" B2621.
- Rear seat: Refer to "DTC Logic" B2622.
- Luggage room: Refer to "DTC Logic" B2623.
Is the inspection result normal?
YES- GO TO 7.
NO- Repair or replace the malfunctioning parts.

7. REPLACE BCM

1.Replace BCM. Refer to "Removal and Installation" Service and Repair.
2.Confirm the operation after replacement.
Is the result normal?
YES- INSPECTION END
NO- Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.