Removal And Installation

WATER PUMP

Removal and Installation


CAUTION:
Replace the electric water pump if it has been dropped or sustained an impact.

REMOVAL

Water Pump 1 (Right)
1.Drain coolant from radiator. Refer to "Draining and Refilling" Coolant Draining And Refilling.

CAUTION:
Perform the operation when the motor is cold.
2.Remove the connector and water hose of the water pump.

CAUTION:
- Take care that coolant does not contact the high voltage harness connectors.
- If coolant contacts a high voltage harness connector, immediately use an air blow and fully remove the liquid.
3.Remove bolts, and remove the electric water pump together with bracket.

CAUTION:
- Take care that coolant does not contact the high voltage harness connectors.
- If coolant contacts a high voltage harness connector, immediately use an air blow and fully remove the liquid.
Water Pump 2 (Left)
1.Remove the left fender protector. Refer to "FENDER PROTECTOR : Removal and Installation" Removal And Installation.
2.Drain coolant from radiator. Refer to "Draining and Refilling" Coolant Draining And Refilling.

CAUTION:
Perform the operation when the motor is cold.
3.Remove the connector of the water pump.
4.Remove the connector and water hose of the water pump.
5.Remove bolts, and remove the electric water pump together with bracket.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
- When installing the water hose to electric water pump, be sure to hold the electric water pump by hand.
- Be sure to perform the air bleeding. Refer to "Draining and Refilling" Coolant Draining And Refilling.