Disassembly and Assembly

COOLING FAN

Disassembly and Assembly


DISASSEMBLY

1.Disconnect sub-harness from cooling fan motor and cooling fan control module.
2.Remove cooling fan control module from fan shroud.

CAUTION:
Handle cooling fan control module carefully and never subjecting it to impact.
3.Remove cooling fan mounting nuts, and then remove the fan.
4.Remove cooling fan motor.
- Identify installation position of each valve. Arrange removed valves so that they cannot be mixed up.

ASSEMBLY

Note the following, and assemble in the reverse order of disassembly.

CAUTION:
RH and LH cooling fans are different. Be careful not to misassemble them.
- If cooling fan motor is reused, install in its original position.
- Install each fan in the following position.
Right side: 9 blades


Left side: 11 blades
- Apply thread locking adhesive to the threads of the cooling fan motor shaft and tighten fan mounting nuts.
- Secure the sub-harness tightly to the fan shroud to prevent it from interfering with the fan rotation area.