Removal And Installation

BREATHER HOSE

Removal and Installation


REMOVAL

1.Remove front under cover. Floor Side Fairing.
2.Use a suitable tool and remove clip, then pull breather hose off brush cover tube part of reduction gear.

INSTALLATION

1.Face a paint mark on breather hose toward left side of vehicle, then fit breather hose (2) over brush cover tube part (1) of reduction gear.





NOTE:
As shown in figure, fit breather hose onto brush cover tube part all the way to its base (A).





2.Install clips (A) into inverter member holes and clip (B) into reduction gear bolt hole.

CAUTION:
Never reuse resin clip (hose clip).





3.Face breather opening in direction (A) shown in figure.