Removal And Installation

YAW RATE/SIDE/DECEL G SENSOR

Removal and Installation


REMOVAL


CAUTION:
To prevent damage to the parts, never drop or strike yaw rate/side/decel G sensor, because it has little endurance to impact. Never use a pneumatic tool.
1.Remove instrument lower cover LH and instrument lower cover RH. Refer to "Removal and Installation" Removal And Installation.
2.Disconnect yaw rate/side/decel G sensor harness connector.
3.Remove yaw rate/side/decel G sensor.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Never drop or strike yaw rate/transverse/decel G sensor, because it has little endurance to impact. Never use a power tool.