Removal And Installation

REAR DOOR LOCK

DOOR LOCK : Removal and Installation


REMOVAL

1.Remove outside handle bracket. Refer to "OUTSIDE HANDLE : Removal and Installation" Service and Repair.
2.Disengage inside handle cable (1) from cable clip (A).





3.Remove lower mounting bolt (B) of partition sash.
4.Disconnect door lock actuator harness connector.
5.Remove door lock assembly TORX bolts.
6.Remove door lock assembly while locating Inside handle cable and door lock cable to the bottom side of rear partition sash.

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
- Check door open/close, lock/unlock operation after installation.
- Check door lock cable is properly engaged with outside handle bracket.





- Check door lock assembly for poor lubrication. Apply body grease to door lock if necessary.