Center Pillar Lower Garnish

BODY SIDE TRIM

CENTER PILLAR LOWER GARNISH : Removal and Installation


CAUTION:
- When removing, always use a remover tool that is made of plastic to prevent damage to the parts.
- Never damage the body.

REMOVAL

1.Fully open front door and rear door.
2.Slide front seat to the fully forward position. Tilt seatback forward.
3.Remove front kicking plate inner and rear kicking plate inner. Refer to "KICKING PLATE INNER : Removal and Installation" Kicking Plate Inner.
4.Remove center pillar lower garnish.





Disengage center pillar lower garnish fixing clips with a remover tool (A), and then remove center pillar lower garnish.


INSTALLATION

Note the following item, and install in the reverse order of removal.

CAUTION:
When installing, check in advance that clips are accurately aligned with the holes on body side, and then install by pressing in.