Hands-Free Phone

HANDLING PRECAUTION

Hands-Free Phone

- In the following cases, the hands-free telephone function is not available.
- When the vehicle moves out of the communication zone of the cellular phone.
- When the vehicle is in a location that may block radio waves such as in an underground parking lot, behind a building, or in mountainous areas.
- When the cellular phone is subject to dial-up limitations such as dial lock, and auto lock, transmission restriction.
- It is not compliant with call waiting function and three-party call function.
- No incoming call can be received just after the key switch is turned to ON.
- For further details about the supported models, consult the Supported Cellular Phone Models in the CARWINGS site.
- Depending on the cellular phone connected, the ring volume may decrease.
- Before connecting a cellular phone, make sure that the operation limitations such as dial lock, auto lock and transmission restriction are cancelled. If any of these settings is found to remain active, disconnect the phone, cancel the setting, and reconnect it.
- When a menu or information is displayed on a cellular phone or when application of standby tool is activated, the function may not be used. Use the cellular phone in the standby status.
- Once a cellular phone is removed, wait at least 10 seconds before reconnecting it.
- When attempting to use a cellular phone, always make sure that the battery charge level is sufficient.
- A snap sound may be heard or the audio signal may be interrupted during a call. This is not a malfunction. It is caused by a switchover to an adjacent cellular zone due to weakening radio waves.
- When the reception status is poor or the surrounding sound level is too large, the voice on the phone may be hard to hear.
- Because the system uses a digital line, the voice on the phone may be distorted or have unpleasant noises due to the surrounding sounds.
- If the vehicle is equipped with a speed trap tracker (radar detector), the speaker may generate noises.
- This unit cannot be used to charge a cellular phone.