Vehicle Cannot Be Set To Ready When Intelligent Key Is Inside Of Vehicle
VEHICLE CANNOT BE SET TO READY WHEN INTELLIGENT KEY IS INSIDE OF VEHICLE
Description
Vehicle cannot be set to READY when brake pedal is depressed and power switch is pressed while carrying
Intelligent Key.
NOTE:
- Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis, and check each symptom.
- The vehicle READY set function, door lock function, power distribution system, and NATS-IVIS/NVIS in the
Intelligent Key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.
Conditions of Vehicle (Operating Conditions)
- "ENGINE START BY I-KEY": ON
Check the setting of "ENGINE START BY I-KEY" in "Work Support" mode of "INTELLIGENT KEY" of "BCM"
using CONSULT.
- One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.
Diagnosis Procedure
1. PERFORM WORK SUPPORT
Perform "INSIDE ANT DIAGNOSIS" in "Work Support" mode of "INTELLIGENT KEY" of "BCM" using CONSLUT.
Refer to "INTELLIGENT KEY : CONSULT Function (BCM INTELLIGENT KEY)" CONSULT Function (BCM - Intelligent Key).
- GO TO 2.
2. CHECK SELF DIAGNOSTIC RESULT
Select "Self Diagnostic Result" mode of "BCM" using CONSULT, and check whether or not DTC of inside key antenna is detected.
Is DTC detected?
YES- Perform the trouble diagnosis for detected DTC.
NO- GO TO 3.
3. CHECK POWER SWITCH
Check power switch.
Refer to "ComponentFunctionCheck" Power Switch.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace malfunctioning parts.
4. CHECK STOP LAMP SWITCH
Check stop lamp switch.
Refer to "Component Inspection" B2555.
Is the inspection result normal?
YES- GO TO 5.
NO- Repair or replace malfunctioning parts.
5. CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES- Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.
NO- GO TO 1.