Removal And Installation

ANTENNA BASE

Removal and Installation


REMOVAL

1.Pull down headlining (rear side) and obtain space for work between vehicle and headlining. Refer to INT32, "Removal and Installation".
2.Disconnect the antenna feeder connector.
3.Remove nuts and remove the antenna base from the vehicle.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Never bend headlining when pull down headlining (rear side).
- When antenna base mounting nut tightening torque is loose, be careful about tightening torque.
Antenna sensitivity becomes poor, and when it is excessive, roof panel may become deformed.